 |
 |
 |
|
Layer Angelina in between 2 layers of organza. This step is not
necessary if you use a hot fix type of Angelina. Stitch out the
designs on a water soluble stabilizer like Wash Away. |
Follow color stops to then
trim away the excess organza and Angelina as you would any appliqué
design |
Dissolve Wash Away and trim
anything that may have been missed when trimming in the hoop. |
 |
 |
 |
|
Lay Out on the shirt as you want them. |
When using Hot fix Angelina (which is what is included in this kit),
instead of using Organza, you can fuse the fiber and lay down as a non
woven fabric |
Follow color stops to then trim away the excess fabric sheet that you
made. |
 |
 |
 |
|
Stitch out leaves directly on the shirt and follow by attaching petals
one at a time. Finish with crystals in the center of the flower. |
Basically the same directions for the dragonfly, stitching one set of
wings directly on the shirt and then attaching the second set of 3-D
wings and the body. Finish with crystals down the back of the
dragonfly. |
Stand Alone flowers and leaves can also be made. The dragonfly is
not stand alone...but the flowers are. |
 |
|
|
|
You will need to order additional Angelina to do the purple flowers.
Red Wing Flash was scattered into Purple Flash. Purple Flash is
Hot Fix and the Red Wing is not...so you need to have the hot fix type
on top and bottom with just a little of the red in between. |
|
|